Updated 04-26-2009
Wanted:
Original jack handle. I have the jack but not handle.
2 1/2" by 28 threaded jam nuts for the original radio.
The rear headliner bow that screws into the cab.
Screw-in cab weather stripping retainers for the door openings. In 1947, these where screwed in. In the later years, they where welded in. These c-channel shaped retainers hold the door rubber in place and are located on the inside of the cab, around the door opening. The PO removed the ones on my truck for some reason.
Passenger side bed to running board filler panel for short bed.
2 stainless ventshades (visors), preferably NOS. Several companies made these but I'm looking for the originals (made by Guide).
1 Fog-King Lamp 5 3/4" Model 101 made by Teleoptic Co. (preferably NOS).
Guide traffic light viewer, perferably NOS if possible. Part number 2233-328.
Transmission crossmember from a 1991 suburban 2500 with a 4L80E transmission.
1954, 1955 1st Series Chevy 5 Window COE or 1950's GMC 920/950/980 (900 series) truck.
1955, 1956 Cadillac (model not important, preferably with factory air conditioning), missing or non-running motor/tranny preferred.
1953, 1955 or 1956 Ford COE (cab-over engine). Could be a Big Job, C500/600/750...series doesn't really matter as long as the cab is mostly complete & in good condition.
1965, 1966 or 1967 Chevelle SS (Super Sport). Must be a genuine super sport (138 vin), not a clone. Missing or non-running motor/tranny preferred.
1964, 1965 Oldsmobile Vista Cruiser, missing or non-running motor/tranny preferred. Preferably without the roof rack.
1953 - 1958 GMC Cannon Ball COE (preferably a GMC F620 or FW620).
1954 Buick Super or Roadmaster preferably with factory air conditioning, missing or non-running motor/tranny preferred.
For Sale:
454 big block serpentine system...$300 obo. | Pictures |
1951 - 1955 1st series truck passenger side door window guide. | Pictures |
Steering column & gear box. Gasket between column & gear box has a small tear in it from separating the two when removing it. | Make offer |
454 thermo-clutch fan for 1983 - 1991 suburbans, blazers & pickup trucks. | Pictures |
1983 - 1986 454 big block suburban efe cold air tube. | Pictures |
454 right hand exhaust manifold with AIR fittings. | Pictures |
Horn & mounting bracket. | Picture | Make offer |
1949 - 1955 1st series factory in-cab truck fuel tank with sending unit. | Pictures | Make offer |
1951 - 1955 1st series pickup truck, suburban & panel truck passenger side window regulator (years that have vent windows). Spline is in good shape. | Pictures | Make offer |
Cab fuel filler neck & new cab grommet. | Pictures |
Non-original Borg Warner voltage regulator assembly for original part 1118843. Refer to Section 12, Sheet 5.00 in assembly manual. | Picture | Make offer |
Fuse block assembly part 1998781. Firewall Mounted, holds 2 fuses, refer to Section 12, Sheet 5.00 in assembly manual. | Make offer |
Horn relay part 1116775. Refer to Section 12, Sheet 5.00 in assembly manual. | Make offer |
Front end conversion to modern tubular shocks using the stock I-beam. Included are two new shocks (have a little rust on the bottom of the shaft from sitting outside under my tarp), two lower (bolt to I-beam) & two upper mounting brackets (bolt to outer side of frame). Also, has replacement u-bolts. Eliminates those old lever action shocks on the front end, yet still keep the stock look. | Picture | Make offer |
Upper brake pedal bracket with new rubber pedal pad. | Make offer |
Lower brake pedal bracket. | Make offer |
Brake/Clutch pedal frame bracket. | Make offer | Picture
Lower clutch pedal bracket. | Make offer |
Brake & clutch tension spring bracket (U shape bracket that was riveted to the frame). | Make offer |